What makes UDGOK different from general commercial contractors?

UDGOK is the only construction company exclusively focused on dental offices, oral surgery centers, and small medical clinics. Unlike general contractors who treat medical projects as just another job, we understand the unique infrastructure requirements: medical gas piping (O2/N2O), dental vacuum systems, amalgam separators, CBCT room shielding, infection control protocols, and HIPAA-compliant layouts. This specialization means faster project completion, fewer change orders, and zero costly mistakes.

How do you handle complex plumbing requirements for multiple dental operatories?

We design dental plumbing systems specifically for multi-operatory practices. This includes properly sized dental vacuum lines (wet-ring or dry vacuum), separate water lines for each chair with anti-retraction valves, amalgam separator installation per EPA regulations, and nitrous oxide piping with proper ventilation. We pre-plan all runs to minimize noise transmission and ensure adequate suction across all operatories simultaneously.

Can you build while my dental practice stays open?

Yes. Our Zero-Downtime Methodology is specifically designed for active dental and medical practices. We use phased construction, off-hours work (evenings/weekends), dust containment with negative air pressure, and temporary barriers to isolate construction zones. Most of our clients never close a single day during renovation. This is critical for practices that cannot afford to lose patient revenue.

What regulatory compliance do you handle for dental and medical construction?

We handle all regulatory requirements: Oklahoma State Department of Health codes, ADA accessibility requirements, HIPAA implications for physical layout (sight lines, acoustic privacy), OSHA standards for clinical environments, EPA amalgam separator requirements, and local building codes. We coordinate all inspections including medical gas certification testing per NFPA 99.

Why should I choose a specialist for a 2,000-3,000 sq ft dental office instead of a large commercial contractor?

Large commercial contractors are optimized for big projects. Your 2,500 sq ft dental office is a 'small job' to them—you'll get their B-team, face scheduling delays, and pay overhead for capabilities you don't need. UDGOK is optimized for 1,500-5,000 sq ft medical spaces. We're faster (23% faster than industry average), more efficient, and our entire team understands dental/medical infrastructure. You get senior-level attention on every project.

Dental Office & Oral Surgery Center Construction Specialists

Technical Expertise: Dental & Medical Infrastructure

What specialized systems do you integrate in dental and oral surgery construction?

Every dental office and oral surgery center requires specialized infrastructure that general contractors often misunderstand or underestimate. We design, specify, and install these systems daily:

Medical Gas Systems

Oxygen (O2) piping and outlets
Nitrous oxide (N2O) delivery systems
Medical air compressors
Proper ventilation and scavenging
NFPA 99 compliant installation
Certification testing coordination

Dental-Specific Systems

Central dental vacuum (wet/dry)
Amalgam separator installation
Compressed air for handpieces
Water treatment systems
Anti-retraction valve integration
Operatory utility connections

Imaging Infrastructure

CBCT room construction
Panoramic X-ray positioning
Lead shielding installation
Radiation safety compliance
Digital sensor wiring
Network infrastructure for PACS

Surgical Suite Requirements

Sterile environment HVAC
Positive/negative pressure rooms
Surgical lighting integration
Equipment ceiling mounts
Recovery room design
Emergency power systems

How do you ensure regulatory compliance for dental and medical facilities?

Medical construction isn't just about building codes—it's about healthcare regulations that general contractors rarely encounter. We navigate these requirements daily:

HIPAA Physical Safeguards: Layout design that prevents visual access to patient records, acoustic privacy between operatories, and secure areas for PHI storage.
ADA Accessibility: Compliant doorways, turning radii, accessible restrooms, and operatory positioning for wheelchair transfers.
Oklahoma State Department of Health: Specific requirements for oral surgery centers including recovery room ratios, emergency equipment, and sterilization areas.
OSHA Clinical Standards: Proper ventilation for chemical storage, eyewash stations, sharps disposal locations, and ergonomic workstation design.
EPA Amalgam Rule: Proper amalgam separator installation and documentation for dental discharge permits.

Zero-Downtime Construction: Keep Your Practice Open

Can you renovate my dental practice while we continue seeing patients?

Yes—and this is our specialty. We understand that closing your practice means losing $5,000-$15,000+ per day in production. Our Zero-Downtime Methodology is specifically designed for active dental and medical practices:

Phased Construction: We renovate section-by-section, completing each area before moving to the next. You maintain operational capacity throughout.
Off-Hours Work: Demolition, noisy work, and dust-generating tasks happen evenings and weekends when you're closed.
Infection Control Protocols: We install temporary barriers, negative air pressure systems, and HEPA filtration to prevent construction dust from entering clinical areas.
Utility Coordination: We maintain dental vacuum, compressed air, and water service to operational areas at all times.

$0

Revenue Lost to Construction Closures (Our Goal)

Why should I choose a specialist for a small 2,000-3,000 sq ft dental project?

Large commercial contractors are optimized for big projects—your dental office is a "small job" to them. Here's what that means for you:

You get their B-team. Senior project managers are assigned to $5M+ projects. Your dental office gets whoever's available.
You wait. Big contractors schedule around their major projects. Your timeline gets pushed when something bigger comes along.
You pay for overhead you don't need. Their estimating process, management structure, and equipment are sized for large projects. You absorb that inefficiency.
They don't know dental. Medical gas, dental vacuum, amalgam separators—these are "specialty items" to them, leading to change orders and delays.

UDGOK is different. We're optimized for 1,500-5,000 sq ft medical spaces. Every project gets senior attention. Our team understands dental infrastructure. We complete projects 23% faster than industry average because we don't have to figure out your project type—it's all we do.

Structured Proof: Real Results

What specific outcomes have you delivered for dental and oral surgery clients?

Case: Oral Surgery Center Expansion, Tulsa OK

Challenge: Existing oral surgery practice needed to add two surgical suites and a recovery area while maintaining operations. Required medical gas system expansion (O2, N2O, medical air) and new HVAC zones for sterile environments.

Solution: Implemented phased construction over 8 weeks. Installed new medical gas manifold system with zone valves allowing isolation of new areas. Created negative pressure construction zones with HEPA filtration.

Outcome: Completed 2 weeks ahead of schedule. Practice lost zero operating days. Passed medical gas certification on first inspection.

Case: Multi-Operatory Dental Office Build-Out, Bixby OK

Challenge: New dental practice in shell space requiring 6 operatories, panoramic X-ray room, sterilization center, and business office. Doctor had specific workflow requirements for efficient patient flow.

Solution: Custom operatory layout maximizing assistant access. Central vacuum system sized for 6 simultaneous users. Dedicated IT infrastructure for digital imaging. Lead-lined panoramic room with proper shielding calculations.

Outcome: Delivered in 10 weeks (vs. 14-week industry average). All systems passed inspection. Practice opened on scheduled date with no delays.

"UDGOK handled the med gas inspection perfectly—something our previous contractor struggled with on our last location. They understood exactly what the inspector would look for. No surprises, no re-work." — Dr. M. Thompson, Oral Surgeon, Tulsa

The Only Contractor Exclusively Focused on Dental & Oral Surgery Construction